Heating Installation in San Antonio & Austin
Gas furnaces, heat pumps, and electric heat — sized for Texas. Federal tax credits and utility rebates handled. Free in-home estimate.
Heating installation in San Antonio and Austin runs $3,500 to $8,000 for a standard furnace, with heat pump conversions adding $1,500-$3,500 on top of a new AC. The right choice depends on whether you already use gas, how cold your specific location gets, and whether you qualify for federal tax credits or utility rebates. We're a dual-licensed HVAC and electrical contractor — when a heat pump or heat strip install needs a panel upgrade or new disconnect, we handle it in the same visit instead of subcontracting.
Which system makes sense for your home?
The right answer depends on your fuel access, climate exposure, and budget.
High-efficiency gas furnace
Best for homes that already have gas service. Fast warm-up, handles hard cold snaps. 96% AFUE models qualify for some rebates.
Cost: $5,000 – $8,000 installed
Heat pump Best value
One system cools and heats. Gets you 30% federal tax credit (up to $2,000) plus CPS / Austin Energy rebates. Best fit for newer homes and electric-only homes.
Cost: +$1,500 – $3,500 over standard AC, often net-cheaper after rebates
Electric heat strips
Lowest install cost. Highest operating cost in a cold snap. Best as backup heat for a heat pump rather than primary heat.
Cost: $1,200 – $2,500 installed
Heating installation FAQ
How much does a new furnace cost in San Antonio? +
A standard 80% efficient gas furnace runs $3,500 to $5,500 installed. A high-efficiency 96% furnace is $5,000 to $8,000. The high-efficiency model saves about 15-20% on gas bills annually and may qualify for utility rebates.
Should I switch to a heat pump? +
For Texas climates, heat pumps make a lot of sense — especially when you're already replacing your AC. The federal Inflation Reduction Act tax credit (30% up to $2,000) plus local utility rebates often makes the heat pump conversion cost-neutral. Trade-off: gas heats faster in a hard freeze. We'll walk you through the math.
How long does a furnace install take? +
One day for a like-for-like replacement. If we're converting fuel type (gas to heat pump), running new electrical, or modifying ductwork, plan on two days.
What tax credits and rebates are available? +
Federal IRA tax credit: 30% of installed cost up to $2,000 for heat pumps. CPS Energy (SA): rebates on high-efficiency heat pump and dual-fuel installs. Austin Energy: Power Saver program rebates. We handle the paperwork for all of these.
Do I need a panel upgrade for a new electric system? +
Sometimes — heat pumps and heat strips can pull significant amperage, and older 100A panels may not have headroom. Because we hold a TX Electrical Contractor License (TECL 317907), we can do the panel evaluation and any upgrade in the same project — no subcontractor delays, no separate invoice.
Free in-home estimate
A licensed tech evaluates your space, your existing system, and walks you through the options with rebates already calculated.